Greenwood Plumbing, Heating & Air Causes of Greenwood Furnace Repairs Skip to main content

Causes of Greenwood Furnace Repairs

Causes of greenwood furnace repairs

As soon as you notice that the general temperature of your house is continuously dropping, there is an excellent chance that your furnace has stopped working. There are various reasons behind this sudden breakdown. Usually, these problems may warrant different types of Greenwood furnace repairs. While some furnace unit problems may be fixed using simple methods, you are not advised to try them. This is because most of these problems need to be addressed with extensive knowledge and high accuracy. If you attempt to address these problems yourself, you risk compromising your safety.

One of the most common criteria for Greenwood furnace repairs is a blown fuse or a tripped breaker. When your fuse breaks down, your furnace indefinitely stops working. This usually happens when your furnace is required to work more than the ideal duration. Also, the ignition on the blower or other electrical components of the furnace may cause the entire circuit to break down. When this happens, you should immediately check the panel of the circuit breaker. While waiting for your contractor to attend to the furnace and the fuse, you may turn off the switch for the furnace first. Aside from that, you may disconnect the fuse that directly connects to the furnace. For this job, your Greenwood heating contractor will need to install a new fuse. Therefore, it is better to have this part ready before the contractor arrives. After the appropriate Greenwood furnace repairs are done, you can expect the furnace to run efficiently again.

Usually, gas furnaces use a small pilot light or flame to create the primary heat source. This pilot light helps in maintaining the proper gas flow to the furnace. There are various reasons that a pilot light breaks down. One of these is the interruption of the gas flow. A draft in the gas flow may also cause the gas flow to be delayed or completely blocked. When this happens, you must contact a contractor to relight your furnace pilot. Before your contractor attends to the pilot light, you may help by turning off the primary power source of the furnace. The recommended method is to turn this off at the thermostat. After extensive Greenwood furnace repairs have been done, you can determine if the pilot light is appropriately working if the flame from the furnace remains lighted after you hold the knob of the gas valve for around a minute.

Another problem you may need help with with your furnace is the presence of a dirty furnace filter. This is one of the common problems because your furnace depends on it every time you turn on the entire unit. When you turn on your heating unit, air starts circulating through the furnace's main part and vents. Along with the air comes the debris. Various debris and dust particles can be stuck on different parts of your furnace. In the long run, dust particles can significantly block air circulation pathways. When this happens, you may notice a decrease in the heating levels that your furnace provides. For this concern, you must contact your contractor to have the filter replaced as soon as possible.

Contact Us Banner

If you are looking for a professional upstate South Carolina plumber, give us a call today at 864-229-7117 or complete our online request form.